Wood Floor Waxing Floor Wax Polishing in Me in Delhi NCR
Wax polishing gives a quick, warm sheen on stone, mosaic and tile floors, and it is the right finish where a hard crystallised surface would be too slippery or too expensive to maintain. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble.
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
At a glance
- 12 years experience
- 600+ projects a year
- Written rates
A real before and after photo is added here for the strongest result.
What is included in wood floor waxing services
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
- Even coverage across lanes and corners
- Edge and skirting hand finishing
- Walkway protection until dry
- Maintenance schedule explained
- Free inspection of surface and existing coating
- Stripping of old wax and residue
What each surface needs
| Surface | Why wax suits it | Result |
|---|---|---|
| Mosaic and terrazzo | Adds sheen without hardening | Warm even gloss |
| Kota and cement floors | Cheap to renew each cycle | Uniform matte to gloss |
| Ceramic and tile | Slip-friendly finish | Clean sheen |
| Stone needing a soft finish | No crystallisation haze | Soft reflective look |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and coating test (free)
- Stripping of old wax and dirt
- Cleaning and drying
- Two thin wax coats with buffing
- Handover with a re-wax schedule
Wood Floor Waxing Services rates in Delhi
| Work | Guide band | Notes |
|---|---|---|
| Strip and re-wax | Rs 5-15 per sq ft | Most floors |
| Deep clean plus wax | Rs 15-25 per sq ft | Heavy build-up |
| Buff only | Rs 5-10 per sq ft | Maintenance cycle |
| Slip-control finish | Quoted after inspection | Wet areas |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Me in Delhi NCR
Wood Floor Waxing Services in Me in Delhi NCR is handled on scheduled routes by our Delhi team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Me in Delhi NCR addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Me in Delhi NCR job handed over for your records
Marble and granite need different treatment
| Marble | Granite | |
|---|---|---|
| Hardness | Softer, scratches more visibly | Harder, resists scratches |
| Acid | Etches immediately, never use | Dulls the surface, avoid |
| Finishing | Diamond pads up to 3000 grit | Its own pad set and compounds |
| Typical aftercare | Sealer every 12-24 months | Sealer on kitchen and stairs |
| Gloss achievable | Very high on hard whites | Deep lustre, not mirror |
We keep separate pad sets and compounds for each, because using marble products on granite (or the reverse) is the fastest way to end up with a hazy surface.
Water and power are the two site requirements. We need one working socket within reach of a lead and a water point; everything else, including masking material and waste bags, comes with the crew.
Quotes are itemised per surface rather than as one lump sum, so a mixed floor of marble, tile and stone is priced line by line and you can approve, defer or drop any line.
Every job ends with a walkthrough. You see the gloss reading, the treated patches and the joints before the crew packs up, and the same crew owns any correction needed later.
Why clients book us
- Old wax fully stripped, never layered over dirt
- Two thin coats instead of one thick coat
- Honest advice when wax is the wrong finish
- Re-wax cycles planned around your traffic
Serving Delhi and nearby areas
The Delhi team operates out of Badarpur, close to the Mathura Road corridor and South Delhi. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble. Inspections are booked within 24-48 hours and most flats are finished the same day. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Wood Floor Waxing Services - common questions
Does wax damage stone?
Not if it is stripped and reapplied properly. Wax left to build up for years traps grit that then scratches the stone underneath, which is the real problem.
Is wax better than crystallisation?
They suit different floors. Crystallisation hardens marble for heavy traffic; wax gives an even sheen on mosaic, Kota and cement floors where hardening would be too aggressive.
Can wax reduce slipperiness?
A waxed surface is less mirror-smooth than a crystallised one, which helps in some areas, but for bathrooms and staircases we recommend a proper anti-skid treatment.
How long does a wax finish last?
Six to twelve weeks in high-traffic areas and three to six months in homes, depending on mopping and footfall. It is renewable, which is why some commercial floors use wax on purpose.
Do you cover Me in Delhi NCR?
Yes. Me in Delhi NCR is on our regular route with the Delhi team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Me in Delhi NCR?
Inspection first, then scheduling. Most Me in Delhi NCR jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
Can you polish a floor that mixes marble and granite?
Yes, and it is common in lobbies and staircases. Each surface is polished to a matching level of sheen rather than the same pad sequence, so the two read as one floor.
Is granite easier to maintain than marble?
It is less acid-sensitive and harder, so it stains and scratches less. It still dulls from repeated wrong cleaning, and it still needs sealing in wet or greasy areas.
Why does marble etch while granite does not?
Marble is calcium-based, so acid dissolves the surface and leaves a white mark. Granite is silicate-based and resists acid better, though strong acid still dulls its polish.