Wax Polishing Floor Wax Polishing in Kota Stone in Delhi NCR
Wax is a sacrificial layer: it takes the traffic wear instead of the stone. On the right floor that is an advantage, and on the wrong floor it traps dirt, so we tell you which one you have. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble.
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
At a glance
- 12 years experience
- 600+ projects a year
- Written rates
A real before and after photo is added here for the strongest result.
What is included in wax polishing
- Two thin coats applied and buffed
- Even coverage across lanes and corners
- Edge and skirting hand finishing
- Walkway protection until dry
- Maintenance schedule explained
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
What each surface needs
| Surface | Why wax suits it | Result |
|---|---|---|
| Mosaic and terrazzo | Adds sheen without hardening | Warm even gloss |
| Kota and cement floors | Cheap to renew each cycle | Uniform matte to gloss |
| Ceramic and tile | Slip-friendly finish | Clean sheen |
| Stone needing a soft finish | No crystallisation haze | Soft reflective look |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and coating test (free)
- Stripping of old wax and dirt
- Cleaning and drying
- Two thin wax coats with buffing
- Handover with a re-wax schedule
Wax Polishing rates in Delhi
| Work | Guide band | Notes |
|---|---|---|
| Strip and re-wax | Rs 5-15 per sq ft | Most floors |
| Deep clean plus wax | Rs 15-25 per sq ft | Heavy build-up |
| Buff only | Rs 5-10 per sq ft | Maintenance cycle |
| Slip-control finish | Quoted after inspection | Wet areas |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Kota Stone in Delhi NCR
Wax Polishing in Kota Stone in Delhi NCR is handled on scheduled routes by our Delhi team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Kota Stone in Delhi NCR addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Kota Stone in Delhi NCR job handed over for your records
What improves, and what cannot be fixed
| Condition | Realistic outcome |
|---|---|
| Dull, even wear | Full gloss returns, looks new |
| Scratch lanes in walkways | Removed, surface level again |
| Light etching and hard water | Removed with polishing |
| Deep etching or acid burns | Faint mark may remain |
| Cracked or hollow slabs | Needs replacement, not polishing |
| Stains soaked through the slab | Lightened, not erased |
We show you this on a test patch before quoting the full job, so the result you see at handover is the result you were promised.
Nothing is hidden behind a shine. Where a surface has damage that polishing cannot correct, we mark it during inspection and put it in writing, so expectations are set before work starts rather than argued over afterwards.
Where a floor has mixed surfaces, each one gets its own pad sequence and compound. Treating Kota stone and imported marble with the same approach is how floors get patchy.
Protection is planned, not improvised. Furniture is moved to one side and covered, curtain hems are lifted, and a walking route is kept clear throughout so the household can still move around.
Why clients book us
- 12 years of floor finishing in Delhi NCR
- Old wax fully stripped, never layered over dirt
- Two thin coats instead of one thick coat
- Honest advice when wax is the wrong finish
Serving Delhi and nearby areas
The Delhi team operates out of Badarpur, close to the Mathura Road corridor and South Delhi. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble. Inspections are booked within 24-48 hours and most flats are finished the same day. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Wax Polishing - common questions
Does wax damage stone?
Not if it is stripped and reapplied properly. Wax left to build up for years traps grit that then scratches the stone underneath, which is the real problem.
Is wax better than crystallisation?
They suit different floors. Crystallisation hardens marble for heavy traffic; wax gives an even sheen on mosaic, Kota and cement floors where hardening would be too aggressive.
Can wax reduce slipperiness?
A waxed surface is less mirror-smooth than a crystallised one, which helps in some areas, but for bathrooms and staircases we recommend a proper anti-skid treatment.
How long does a wax finish last?
Six to twelve weeks in high-traffic areas and three to six months in homes, depending on mopping and footfall. It is renewable, which is why some commercial floors use wax on purpose.
Do you cover Kota Stone in Delhi NCR?
Yes. Kota Stone in Delhi NCR is on our regular route with the Delhi team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Kota Stone in Delhi NCR?
Inspection first, then scheduling. Most Kota Stone in Delhi NCR jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
Can the floor look exactly new again?
On sound stone with surface wear, yes. Where damage has gone deeper, such as acid burns or stains soaked through the slab, the result is a major improvement rather than perfection, and we tell you which one to expect before starting.
Why do some floors come back brighter than others?
Stone type and previous care. White and hard marbles take a higher gloss; softer or previously acid-washed floors top out lower. Consistent cleaning products are what keep the difference from widening.
Do you guarantee the same result on every surface?
No, and no honest contractor should. A mixed floor gets one uniform gloss level chosen after testing each surface, which sometimes means a satin finish rather than mirror.