Wax Polishing Floor Wax Polishing in Cement Floor in Delhi NCR
Wax polishing gives a quick, warm sheen on stone, mosaic and tile floors, and it is the right finish where a hard crystallised surface would be too slippery or too expensive to maintain. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble.
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
At a glance
- 12 years experience
- 600+ projects a year
- Written rates
A real before and after photo is added here for the strongest result.
What is included in wax polishing
- Two thin coats applied and buffed
- Even coverage across lanes and corners
- Edge and skirting hand finishing
- Walkway protection until dry
- Maintenance schedule explained
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
What each surface needs
| Surface | Why wax suits it | Result |
|---|---|---|
| Mosaic and terrazzo | Adds sheen without hardening | Warm even gloss |
| Kota and cement floors | Cheap to renew each cycle | Uniform matte to gloss |
| Ceramic and tile | Slip-friendly finish | Clean sheen |
| Stone needing a soft finish | No crystallisation haze | Soft reflective look |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and coating test (free)
- Stripping of old wax and dirt
- Cleaning and drying
- Two thin wax coats with buffing
- Handover with a re-wax schedule
Wax Polishing rates in Delhi
| Work | Guide band | Notes |
|---|---|---|
| Strip and re-wax | Rs 5-15 per sq ft | Most floors |
| Deep clean plus wax | Rs 15-25 per sq ft | Heavy build-up |
| Buff only | Rs 5-10 per sq ft | Maintenance cycle |
| Slip-control finish | Quoted after inspection | Wet areas |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Cement Floor in Delhi NCR
Wax Polishing in Cement Floor in Delhi NCR is handled on scheduled routes by our Delhi team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Cement Floor in Delhi NCR addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Cement Floor in Delhi NCR job handed over for your records
Night, weekend and occupied-premises work
- Evening, night and Sunday slots so trading hours and office shifts are untouched
- Machine noise managed around residents, guests and neighbours, with work sequenced floor by floor
- Zones handed back ready for use before the next shift or opening time
- Lighting provided where a site has no working lights after hours
- Supervisor present throughout, with one point of contact for the site manager
Working after hours costs a little more in crew arrangements, and we tell you that upfront rather than burying it in the rate.
Access is confirmed before the visit: parking, lift use, gate entry, working-hour restrictions and any society paperwork. Sorting this in advance is what stops a scheduled job from becoming a wasted trip.
Old polish, wax and cleaning residue are stripped before any new finish goes on. Layering a fresh treatment over residue is what makes floors look grey again within weeks.
Water and power are the two site requirements. We need one working socket within reach of a lead and a water point; everything else, including masking material and waste bags, comes with the crew.
Why clients book us
- Old wax fully stripped, never layered over dirt
- Two thin coats instead of one thick coat
- Honest advice when wax is the wrong finish
- Re-wax cycles planned around your traffic
Serving Delhi and nearby areas
The Delhi team operates out of Badarpur, close to the Mathura Road corridor and South Delhi. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble. Inspections are booked within 24-48 hours and most flats are finished the same day. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Wax Polishing - common questions
How long does a wax finish last?
Six to twelve weeks in high-traffic areas and three to six months in homes, depending on mopping and footfall. It is renewable, which is why some commercial floors use wax on purpose.
Does wax damage stone?
Not if it is stripped and reapplied properly. Wax left to build up for years traps grit that then scratches the stone underneath, which is the real problem.
Is wax better than crystallisation?
They suit different floors. Crystallisation hardens marble for heavy traffic; wax gives an even sheen on mosaic, Kota and cement floors where hardening would be too aggressive.
Can wax reduce slipperiness?
A waxed surface is less mirror-smooth than a crystallised one, which helps in some areas, but for bathrooms and staircases we recommend a proper anti-skid treatment.
Do you cover Cement Floor in Delhi NCR?
Yes. Cement Floor in Delhi NCR is on our regular route with the Delhi team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Cement Floor in Delhi NCR?
Inspection first, then scheduling. Most Cement Floor in Delhi NCR jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
Is there a premium for night work?
Sometimes, and we say so before booking. It covers crew scheduling and transport at unsociable hours, not the work itself.
Can you work while our premises stay open?
Yes. Work is phased section by section, with dry paths and signage so customers and staff are never crossing a wet or machine-worked area.
Will the machines disturb neighbours?
Machine noise is unavoidable for short periods. We sequence the noisiest work earlier, and for residential buildings we stay within the society's permitted hours.