Tile Waxing Floor Wax Polishing in Delhi NCR
Wax polishing gives a quick, warm sheen on stone, mosaic and tile floors, and it is the right finish where a hard crystallised surface would be too slippery or too expensive to maintain. Delhi NCR mixes very old housing stock with new high-rise towers, so a single visit can mean Kota stone in one room and Italian marble in the next. We carry pads for both and quote each surface on its own merit.
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
At a glance
- 12 years experience
- 600+ projects a year
- Written rates
A real before and after photo is added here for the strongest result.
What is included in tile waxing
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
- Even coverage across lanes and corners
- Edge and skirting hand finishing
- Walkway protection until dry
- Maintenance schedule explained
- Free inspection of surface and existing coating
What each surface needs
| Surface | Why wax suits it | Result |
|---|---|---|
| Mosaic and terrazzo | Adds sheen without hardening | Warm even gloss |
| Kota and cement floors | Cheap to renew each cycle | Uniform matte to gloss |
| Ceramic and tile | Slip-friendly finish | Clean sheen |
| Stone needing a soft finish | No crystallisation haze | Soft reflective look |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and coating test (free)
- Stripping of old wax and dirt
- Cleaning and drying
- Two thin wax coats with buffing
- Handover with a re-wax schedule
Tile Waxing rates in Delhi NCR
| Work | Guide band | Notes |
|---|---|---|
| Strip and re-wax | Rs 5-15 per sq ft | Most floors |
| Deep clean plus wax | Rs 15-25 per sq ft | Heavy build-up |
| Buff only | Rs 5-10 per sq ft | Maintenance cycle |
| Slip-control finish | Quoted after inspection | Wet areas |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Keeping the finish after the job is done
| Habit | Why it matters |
|---|---|
| Dry dust mopping | Removes grit before it scratches the surface |
| pH-neutral cleaner only | Acid etches marble and bleach dulls the finish |
| Damp mop, never flooding | Standing water leaves marks and weakens joints |
| Mats at entries | Captures grit where it enters |
| Felt pads under furniture | Stops drag marks on polished surfaces |
- A light maintenance polish every 12-18 months keeps gloss without a full job
- Commercial floors are usually re-polished annually, homes every two years
- Sealer or nano coating, where applied, is refreshed on the schedule we hand over
Every job ends with a walkthrough. You see the gloss reading, the treated patches and the joints before the crew packs up, and the same crew owns any correction needed later.
After-care guidance is handed over in writing: which cleaner to use, how to mop, and what to avoid during the first week. Most repeat problems trace back to cleaning products rather than the work itself.
Why clients book us
- 12 years of floor finishing in Delhi NCR
- Old wax fully stripped, never layered over dirt
- Two thin coats instead of one thick coat
- Honest advice when wax is the wrong finish
Serving Delhi NCR and nearby areas
Our Badarpur (Mathura Road) and Gurgaon (Badshahpur, Sector 48) teams cover the whole NCR belt. Delhi NCR mixes very old housing stock with new high-rise towers, so a single visit can mean Kota stone in one room and Italian marble in the next. We carry pads for both and quote each surface on its own merit. Inspections are booked within 24-48 hours and most jobs take 1-2 days. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Tile Waxing - common questions
How long does a wax finish last?
Six to twelve weeks in high-traffic areas and three to six months in homes, depending on mopping and footfall. It is renewable, which is why some commercial floors use wax on purpose.
Does wax damage stone?
Not if it is stripped and reapplied properly. Wax left to build up for years traps grit that then scratches the stone underneath, which is the real problem.
Is wax better than crystallisation?
They suit different floors. Crystallisation hardens marble for heavy traffic; wax gives an even sheen on mosaic, Kota and cement floors where hardening would be too aggressive.
Can wax reduce slipperiness?
A waxed surface is less mirror-smooth than a crystallised one, which helps in some areas, but for bathrooms and staircases we recommend a proper anti-skid treatment.
How often does the floor need a maintenance polish?
Every 12-18 months for homes and every 8-12 months for commercial floors. It is a much smaller job than the original restoration.
Which cleaner should we use?
A pH-neutral stone cleaner with clean water, dried after mopping. Avoid acid, bleach and abrasive powders, which are the main causes of dull and etched floors.
Can maintenance work be done room by room?
Yes. We schedule it in sections so the house stays usable, and it takes a fraction of the time of a full polish.