Tile Wax Polishing Floor Wax Polishing in Delhi NCR
Wax is a sacrificial layer: it takes the traffic wear instead of the stone. On the right floor that is an advantage, and on the wrong floor it traps dirt, so we tell you which one you have. Delhi NCR mixes very old housing stock with new high-rise towers, so a single visit can mean Kota stone in one room and Italian marble in the next. We carry pads for both and quote each surface on its own merit.
- Free inspection of surface and existing coating
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
At a glance
- 12 years experience
- 600+ projects a year
- Written rates
A real before and after photo is added here for the strongest result.
What is included in tile wax polishing
- Stripping of old wax and residue
- Floor cleaned and fully dried before waxing
- Two thin coats applied and buffed
- Even coverage across lanes and corners
- Edge and skirting hand finishing
- Walkway protection until dry
- Maintenance schedule explained
- Free inspection of surface and existing coating
What each surface needs
| Surface | Why wax suits it | Result |
|---|---|---|
| Mosaic and terrazzo | Adds sheen without hardening | Warm even gloss |
| Kota and cement floors | Cheap to renew each cycle | Uniform matte to gloss |
| Ceramic and tile | Slip-friendly finish | Clean sheen |
| Stone needing a soft finish | No crystallisation haze | Soft reflective look |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and coating test (free)
- Stripping of old wax and dirt
- Cleaning and drying
- Two thin wax coats with buffing
- Handover with a re-wax schedule
Tile Wax Polishing rates in Delhi NCR
| Work | Guide band | Notes |
|---|---|---|
| Strip and re-wax | Rs 5-15 per sq ft | Most floors |
| Deep clean plus wax | Rs 15-25 per sq ft | Heavy build-up |
| Buff only | Rs 5-10 per sq ft | Maintenance cycle |
| Slip-control finish | Quoted after inspection | Wet areas |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Looking after the finish
| Timeframe | What to do |
|---|---|
| First 24 hours | Stay off coated areas, keep furniture off the floor |
| First week | Dry mop only, no wet mopping, no chemical cleaners |
| Ongoing | pH-neutral cleaner, damp mop, dry after |
| Every 12-18 months | Light maintenance polish to hold the gloss |
- Never use acid, bleach, vinegar or abrasive powder on stone
- Wipe spills promptly, particularly lemon, tea and oil
- Use felt pads on furniture and mats at entry points
- Keep planters and metal legs off wet floors to prevent rust rings
Every job ends with a walkthrough. You see the gloss reading, the treated patches and the joints before the crew packs up, and the same crew owns any correction needed later.
After-care guidance is handed over in writing: which cleaner to use, how to mop, and what to avoid during the first week. Most repeat problems trace back to cleaning products rather than the work itself.
Why clients book us
- Old wax fully stripped, never layered over dirt
- Two thin coats instead of one thick coat
- Honest advice when wax is the wrong finish
- Re-wax cycles planned around your traffic
Serving Delhi NCR and nearby areas
Our Badarpur (Mathura Road) and Gurgaon (Badshahpur, Sector 48) teams cover the whole NCR belt. Delhi NCR mixes very old housing stock with new high-rise towers, so a single visit can mean Kota stone in one room and Italian marble in the next. We carry pads for both and quote each surface on its own merit. Inspections are booked within 24-48 hours and most jobs take 1-2 days. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Tile Wax Polishing - common questions
Does wax damage stone?
Not if it is stripped and reapplied properly. Wax left to build up for years traps grit that then scratches the stone underneath, which is the real problem.
Is wax better than crystallisation?
They suit different floors. Crystallisation hardens marble for heavy traffic; wax gives an even sheen on mosaic, Kota and cement floors where hardening would be too aggressive.
Can wax reduce slipperiness?
A waxed surface is less mirror-smooth than a crystallised one, which helps in some areas, but for bathrooms and staircases we recommend a proper anti-skid treatment.
How long does a wax finish last?
Six to twelve weeks in high-traffic areas and three to six months in homes, depending on mopping and footfall. It is renewable, which is why some commercial floors use wax on purpose.
What should I avoid in the first week?
Wet mopping, chemical floor cleaners, dragging furniture and placing potted plants back on the floor. Dry mopping and clean water only until the finish settles.
Which cleaner do you recommend?
Any pH-neutral stone cleaner, used with clean water and followed by drying. That single habit prevents most of the dullness and staining we are called back to fix.
What voids the finish durability?
Acid and abrasive cleaning. A floor polished this month can look dull in eight weeks if it is mopped with an acidic general-purpose cleaner.