Floor Polishing Services in Bangalore
A mixed floor is normal in Bangalore homes: Kota in one room, Italian marble in the living area and vitrified tile in the kitchen. One team can handle all three in the same visit, which also avoids arguments between contractors. Bangalore is granite country, so most homes mix granite platforms and staircases with marble or vitrified floors. Hard borewell water leaves scale and white film on stone, which is why descaling is usually part of the job here.
- Damage mapping and crack depth check
- Joints cleaned so epoxy bonds properly
- Pigment matched against the stone shade
- Thin epoxy for hairline joints, gel for deep cracks
At a glance
- One team, all surfaces
- Written rates
- Klindex & Taski
A real before and after photo is added here for the strongest result.
What is included in floor polishing
- Damage mapping and crack depth check
- Joints cleaned so epoxy bonds properly
- Pigment matched against the stone shade
- Thin epoxy for hairline joints, gel for deep cracks
- Full cure before shaping and polishing
- Edges and corners hand finished
- Polish matched to the surrounding floor
- Optional sealing over repaired areas
What each surface needs
| Damage | Method | Result |
|---|---|---|
| Open slab joints | Thin epoxy run in and levelled | Closed joint, no dirt trap |
| Chipped edges and corners | Epoxy built up and shaped | Edge rebuilt to profile |
| Cracked stair nosing | Deep tinted gel fill | Safe to walk on |
| Dull patchy gloss | Epoxy polish coat after diamond polishing | Bright even finish |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection to check whether the crack is cosmetic or structural (free)
- Cleaning of joints and cracks
- Tinted epoxy applied and left to cure
- Fill shaped flush and polished
- Handover with photos and advice on furniture that caused it
Floor Polishing rates in Bangalore
| Work | Pricing | Notes |
|---|---|---|
| Joint and crack filling | Per running ft | Colour matched |
| Chip and edge rebuilding | Per repair | Shaped and polished |
| Epoxy polish over a floor | Rs 15-25 per sq ft | After diamond polishing |
| Deep epoxy sequence with crystallisation | Rs 25-35 per sq ft | Heavy patchiness |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
What changes the price for floor polishing in Bangalore
| Factor | Effect on rate | What to expect |
|---|---|---|
| Total area | Bigger areas cost less per sq ft | Slab rates above 1,000 sq ft |
| Damage depth | Grinding raises the rate | Decided by the test patch |
| Stone type | Imported and filled slabs take longer | See the surface table |
| Access | Upper floors and corners take longer | Confirmed before booking |
Ask for one written rate per surface. A single number for the whole house without an inspection always changes later.
The problems we are usually called for
| Problem | What causes it | Fix |
|---|---|---|
| Overall dullness | Worn finish, cleaning residue | Strip and re-polish |
| Scratch lanes | Grit walked in from entrances | Diamond polish those lanes |
| Grey or black patches | Water trapped, old polish build-up | Grind, dry, polish, seal |
| White watermark rings | Planters, metal legs, spills | Poultice and re-polish |
| Loose or black joints | Failed grouting, water ingress | Cut out and re-point |
| Slippery when wet | Gloss in a wet area | Satin finish plus anti-skid |
Send a photo of the worst patch on WhatsApp and we will tell you which of these it is before anyone visits.
Waste is removed the same day. Slurry, stripped residue, used pads and packaging leave with the crew instead of going into society bins or being left for you to dispose of.
Nothing is hidden behind a shine. Where a surface has damage that polishing cannot correct, we mark it during inspection and put it in writing, so expectations are set before work starts rather than argued over afterwards.
After-care guidance is handed over in writing: which cleaner to use, how to mop, and what to avoid during the first week. Most repeat problems trace back to cleaning products rather than the work itself.
Why clients book us
- Epoxy 1005 and Akemi 5010 gel in stock
- Pigment matched to the stone, never a grey patch
- Full cure before polishing, because rushing is why fills sink
- Repairs photographed before and after
Serving Bangalore and nearby areas
Bangalore visits are planned as a batch with machines brought in, so work is booked in advance rather than as same-day calls. Bangalore is granite country, so most homes mix granite platforms and staircases with marble or vitrified floors. Hard borewell water leaves scale and white film on stone, which is why descaling is usually part of the job here. Inspections are booked within 24-48 hours and most jobs take 1-2 days. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Floor Polishing - common questions
How long does an epoxy repair last?
Years under normal traffic, provided the surrounding slab is sound. If a slab is hollow or still moving, the underlying problem must be fixed first and we check that during inspection.
Is epoxy polishing the same as diamond polishing?
No. Diamond polishing refines the stone with abrasives. Epoxy polishing adds a brightening and protective treatment and works best on top of a properly polished floor.
Do we have to leave the room while it cures?
Only the work area needs to stay clear. Small fills cure in a few hours; larger repairs are left overnight before shaping and polishing.
Will the repaired crack show?
With a matched tint and a flush polish it blends into the veining and is hard to find from standing height. A faint line can remain under close direct light, which is normal.
Is the price negotiable?
The rate per sq ft is not inflated to leave room for haggling. We scope honestly: if the floor needs only a buff, we quote a buff instead of a full diamond job, and tell you when the cheaper option will hold.
Do you take advance payment?
The package is confirmed in writing first. Advance for material is normal on large jobs; the balance is settled after the walkthrough.
Which of these can you fix in one visit?
Dullness, scratch lanes, watermark rings and slippery surfaces are usually single-visit jobs. Trapped water, loose joints and cracked or hollow slabs may need a second visit because of drying or re-pointing time.
What if the damage is worse than the photos showed?
We stop and re-quote rather than continuing on a guess. You approve the revised scope or we finish what was agreed and leave the rest.
Can repeated problems be prevented?
Most of them, yes. Entrance mats, pH-neutral cleaning, felt pads and prompt spill wipe-up remove the four causes behind the majority of callbacks.