Marble Stone in Delhi NCR
Marble, granite, tile, terrazzo and wooden floors all dull for different reasons, and treating them with the same machine and pads is how floors get damaged. We identify the surface first, then use the sequence that suits it. Delhi NCR mixes very old housing stock with new high-rise towers, so a single visit can mean Kota stone in one room and Italian marble in the next. We carry pads for both and quote each surface on its own merit.
- Free inspection of gloss, stains and joint condition
- Masking of skirting, walls and fittings
- Granite-specific pad sequence for the stone type
- Buffing to bring back depth and clarity
At a glance
- One team, all surfaces
- Written rates
- Klindex & Taski
A real before and after photo is added here for the strongest result.
What is included in marble stone maintenance
- Granite-specific pad sequence for the stone type
- Buffing to bring back depth and clarity
- Stain treatment for oil, rust and hard water
- Joint cleaning between slabs
- Sealing or nano coating on request
- Wash-down and gloss check with you
- Free inspection of gloss, stains and joint condition
- Masking of skirting, walls and fittings
What each surface needs
| Surface | Process | Result |
|---|---|---|
| Dark granite (black, brown) | Fine buff with matched pads | Deep reflective lustre |
| Light granite (grey, speckled) | Polish, then seal | Even satin to gloss |
| Granite kitchen platform | Clean, buff, seal | Stain-resistant working surface |
| Granite staircase and threshold | Edge buff and hand polish | Uniform gloss across edges |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and gloss reading (free)
- Masking and surface preparation
- Granite pad sequence and buffing
- Stain treatment where required
- Sealing, wash-down and handover
Marble Stone Maintenance rates in Delhi NCR
| Work | Guide band | Typical case |
|---|---|---|
| Granite buffing | Rs 5-15 per sq ft | Sound floor, mild dulling |
| Diamond polishing of granite | Rs 15-25 per sq ft | Scratch lanes, worn gloss |
| Deep restoration | Rs 25-35 per sq ft | Heavy wear, stains |
| Granite sealing or nano coating | Quoted after inspection | Kitchen platforms, staircases |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Booking a crew near you
- Crews operate from two bases, so most addresses in the service cities are reached the same day for inspection
- Inspections are booked within 24-48 hours, and one-day jobs are often scheduled within the same week
- Society gate, lift and parking permissions are arranged before the crew arrives
- Machines, water supply and power needs are confirmed at booking, so nothing delays the start
- Local route days keep travel short, which keeps the per sq ft rate down
If your address is outside the listed service cities, ask before booking. We tell you honestly whether we can cover it, instead of sending a crew that bills travel into the job.
Payment terms are stated upfront: advances apply only where material has to be bought for a large job, and the balance is settled after the walkthrough so you are never paying for work you have not seen.
Every job ends with a walkthrough. You see the gloss reading, the treated patches and the joints before the crew packs up, and the same crew owns any correction needed later.
Weight and load matter on upper floors and terraces. Where a slab has been laid over a void or a lightweight screed, we reduce machine weight and speed rather than risk cracking the base.
Why clients book us
- Sealing recommended where spills are frequent
- Samples tested on a hidden corner first
- One team for granite, marble, tile and wood
- 12 years of granite and marble work in Delhi NCR
Serving Delhi NCR and nearby areas
Our Badarpur (Mathura Road) and Gurgaon (Badshahpur, Sector 48) teams cover the whole NCR belt. Delhi NCR mixes very old housing stock with new high-rise towers, so a single visit can mean Kota stone in one room and Italian marble in the next. We carry pads for both and quote each surface on its own merit. Inspections are booked within 24-48 hours and most jobs take 1-2 days. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Stone Maintenance - common questions
Does granite need sealing?
Granite is less porous than marble but still benefits from sealing in kitchens and on staircases where water and oil sit. Sealed surfaces hold their look noticeably longer.
Can acid cleaners be used on granite?
No. Acid dulls the polished surface and can bleach the colour. Use pH-neutral cleaner and dry promptly.
How often should granite be polished?
Homes at 18-24 months, commercial floors at 8-12 months depending on traffic and cleaning method.
Can dull granite really be brought back?
Yes if the dullness is surface wear. Buffing with the correct pads restores depth and reflectivity. Stone that has been damaged by acid or heavy abrasion may need grinding first, and we will tell you after seeing it.
How soon can someone come for an inspection?
Usually within 24-48 hours in our service cities. If you are on a route day, it can be the same day.
Do you cover my area?
Send the locality or PIN code and we will confirm. We would rather decline a job than travel from far and load that cost onto your rate.
Can the work be done on a weekend?
Yes. Weekend and after-hours slots are normal for occupied homes and commercial premises.