Marble Floor Polishing in Netaji Nagar
If your marble has lost its gloss, shows grey walking lanes or looks hazy after mopping, the finish has worn through to the stone. We restore it with a graded diamond sequence and lock the shine in, so the floor holds its look instead of going flat again in a few weeks. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit.
- Free inspection of porosity and stain history
- Deep cleaning before sealing (sealer over dirt seals dirt)
- Drying time allowed, no sealing on damp stone
- Impregnating sealer applied evenly
At a glance
- Diamond polishing
- Stain removal
- Rate locked in writing
A real before and after photo is added here for the strongest result.
What is included in marble floor polishing
- Deep cleaning before sealing (sealer over dirt seals dirt)
- Drying time allowed, no sealing on damp stone
- Impregnating sealer applied evenly
- Second coat on high-absorption stone
- Buffer and residue removal
- Wet-area and kitchen priority treatment
- Maintenance and re-seal schedule explained
- Free inspection of porosity and stain history
What each surface needs
| Stone | Absorption | Seal priority |
|---|---|---|
| Marble | Medium, acid and oil sensitive | Kitchens, entries, washbasins |
| Limestone | High | All wet areas |
| Granite | Low | Kitchen platforms, stairs |
| Travertine | High, pitted | Bathrooms, outdoors |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and porosity test (free)
- Deep cleaning and residue removal
- Full drying of the stone surface
- Sealer applied in even coats
- Buffing, handover and re-seal schedule
Marble Floor Polishing rates in Kolkata
| Work | Guide band | Notes |
|---|---|---|
| Clean and seal | Rs 5-15 per sq ft | Dry floors and walls |
| Strip, clean and seal | Rs 15-25 per sq ft | Old coating present |
| High-absorption stone, two coats | Quoted after inspection | Limestone and travertine |
| Re-seal cycle | Per sq ft | Every 12-24 months |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Netaji Nagar
Marble Floor Polishing in Netaji Nagar is handled on scheduled routes by our Kolkata team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Netaji Nagar addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Netaji Nagar job handed over for your records
Buff or full polish? A straight answer
| Condition of the floor | Correct job | Why |
|---|---|---|
| Dull but even, no scratches | Buff only | Surface is sound, only the sheen is lost |
| Light scratches and lane wear | Diamond polish | Surface layer needs refining |
| Visible lippage or deep scratches | Grinding plus polish | Buffing cannot level stone |
| Wax or polish residue build-up | Strip, then polish | New finish will not bond over residue |
Buffing is the cheaper option and we will tell you when it is enough. Selling a full polish for a floor that only needed a buff is how a contractor gets a bad name.
Where a floor has mixed surfaces, each one gets its own pad sequence and compound. Treating Kota stone and imported marble with the same approach is how floors get patchy.
Water and power are the two site requirements. We need one working socket within reach of a lead and a water point; everything else, including masking material and waste bags, comes with the crew.
Payment terms are stated upfront: advances apply only where material has to be bought for a large job, and the balance is settled after the walkthrough so you are never paying for work you have not seen.
Why clients book us
- Honest about what sealing does and does not do
- Re-seal cycle scheduled so protection never lapses
- 12 years of stone care
- Sealer applied only on clean, dry stone
Serving Kolkata and nearby areas
Kolkata jobs are scheduled as a fixed visit batch so the crew and machines travel together and travel cost is not loaded onto your rate. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit. Inspections are booked within 24-48 hours and most jobs take 1-2 days per flat. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Floor Polishing - common questions
How often should stone be re-sealed?
Every twelve to twenty-four months for working areas like kitchens, entries and washbasins. Dry bedroom floors and walls hold sealer much longer.
Can sealer be applied over an old polish?
No. It will not bond, and it traps the old residue underneath. Cleaning or stripping first is part of the job, not an optional extra.
Does sealing change the colour?
Impregnating sealers are colourless. If a sealer darkens the stone, it is a film-forming product rather than an impregnator, which is a different finish choice.
Will sealing make my marble stain-proof?
No, and any contractor saying that is overselling. Sealing buys you time to wipe a spill. Lemon juice or oil left overnight can still mark sealed stone.
Do you cover Netaji Nagar?
Yes. Netaji Nagar is on our regular route with the Kolkata team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Netaji Nagar?
Inspection first, then scheduling. Most Netaji Nagar jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
How do I know if buffing is enough?
If the floor is evenly dull with no visible scratch pattern, a buff usually restores it. If you can see lanes, scratches or a step between slabs, it needs polishing or grinding, and we show you why on a test patch.
Is buffing a waste of money then?
Not at all. It is the correct maintenance step for a sound floor and costs a fraction of a full job. It becomes a waste only when the surface damage needs something deeper.
Can you do a test patch first?
Yes, on every job. One tile or a corner, so you judge the actual result before committing to the whole floor.