Marble Floor Polishing in Laketown
Marble does not fade evenly. Doorways, kitchen entries and stair landings wear first, which is why floors start looking patchy. We polish the whole surface back to one uniform gloss so no room looks newer than the rest. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit.
- Free inspection of gloss, stains and joint condition
- Masking of skirting, walls and fittings
- Granite-specific pad sequence for the stone type
- Buffing to bring back depth and clarity
At a glance
- Diamond polishing
- Stain removal
- Rate locked in writing
A real before and after photo is added here for the strongest result.
What is included in marble floor polishing
- Granite-specific pad sequence for the stone type
- Buffing to bring back depth and clarity
- Stain treatment for oil, rust and hard water
- Joint cleaning between slabs
- Sealing or nano coating on request
- Wash-down and gloss check with you
- Free inspection of gloss, stains and joint condition
- Masking of skirting, walls and fittings
What each surface needs
| Surface | Process | Result |
|---|---|---|
| Dark granite (black, brown) | Fine buff with matched pads | Deep reflective lustre |
| Light granite (grey, speckled) | Polish, then seal | Even satin to gloss |
| Granite kitchen platform | Clean, buff, seal | Stain-resistant working surface |
| Granite staircase and threshold | Edge buff and hand polish | Uniform gloss across edges |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and gloss reading (free)
- Masking and surface preparation
- Granite pad sequence and buffing
- Stain treatment where required
- Sealing, wash-down and handover
Marble Floor Polishing rates in Kolkata
| Work | Guide band | Typical case |
|---|---|---|
| Granite buffing | Rs 5-15 per sq ft | Sound floor, mild dulling |
| Diamond polishing of granite | Rs 15-25 per sq ft | Scratch lanes, worn gloss |
| Deep restoration | Rs 25-35 per sq ft | Heavy wear, stains |
| Granite sealing or nano coating | Quoted after inspection | Kitchen platforms, staircases |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Laketown
Marble Floor Polishing in Laketown is handled on scheduled routes by our Kolkata team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Laketown addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Laketown job handed over for your records
Keeping the finish after the job is done
| Habit | Why it matters |
|---|---|
| Dry dust mopping | Removes grit before it scratches the surface |
| pH-neutral cleaner only | Acid etches marble and bleach dulls the finish |
| Damp mop, never flooding | Standing water leaves marks and weakens joints |
| Mats at entries | Captures grit where it enters |
| Felt pads under furniture | Stops drag marks on polished surfaces |
- A light maintenance polish every 12-18 months keeps gloss without a full job
- Commercial floors are usually re-polished annually, homes every two years
- Sealer or nano coating, where applied, is refreshed on the schedule we hand over
Access is confirmed before the visit: parking, lift use, gate entry, working-hour restrictions and any society paperwork. Sorting this in advance is what stops a scheduled job from becoming a wasted trip.
Old polish, wax and cleaning residue are stripped before any new finish goes on. Layering a fresh treatment over residue is what makes floors look grey again within weeks.
Water and power are the two site requirements. We need one working socket within reach of a lead and a water point; everything else, including masking material and waste bags, comes with the crew.
Why clients book us
- Sealing recommended where spills are frequent
- Samples tested on a hidden corner first
- One team for granite, marble, tile and wood
- 12 years of granite and marble work
Serving Kolkata and nearby areas
Kolkata jobs are scheduled as a fixed visit batch so the crew and machines travel together and travel cost is not loaded onto your rate. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit. Inspections are booked within 24-48 hours and most jobs take 1-2 days per flat. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Floor Polishing - common questions
Can dull granite really be brought back?
Yes if the dullness is surface wear. Buffing with the correct pads restores depth and reflectivity. Stone that has been damaged by acid or heavy abrasion may need grinding first, and we will tell you after seeing it.
Does granite need sealing?
Granite is less porous than marble but still benefits from sealing in kitchens and on staircases where water and oil sit. Sealed surfaces hold their look noticeably longer.
Can acid cleaners be used on granite?
No. Acid dulls the polished surface and can bleach the colour. Use pH-neutral cleaner and dry promptly.
How often should granite be polished?
Homes at 18-24 months, commercial floors at 8-12 months depending on traffic and cleaning method.
Do you cover Laketown?
Yes. Laketown is on our regular route with the Kolkata team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Laketown?
Inspection first, then scheduling. Most Laketown jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
How often does the floor need a maintenance polish?
Every 12-18 months for homes and every 8-12 months for commercial floors. It is a much smaller job than the original restoration.
Which cleaner should we use?
A pH-neutral stone cleaner with clean water, dried after mopping. Avoid acid, bleach and abrasive powders, which are the main causes of dull and etched floors.
Can maintenance work be done room by room?
Yes. We schedule it in sections so the house stays usable, and it takes a fraction of the time of a full polish.