Marble Floor Polishing in Kudghat
If your marble has lost its gloss, shows grey walking lanes or looks hazy after mopping, the finish has worn through to the stone. We restore it with a graded diamond sequence and lock the shine in, so the floor holds its look instead of going flat again in a few weeks. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit.
- Free inspection with a residue test on a hidden patch
- Masking and protection of adjacent surfaces
- Residue and soap film stripping with pH-neutral products
- Deep cleaning of joints and edges
At a glance
- Diamond polishing
- Stain removal
- Rate locked in writing
A real before and after photo is added here for the strongest result.
What is included in marble floor polishing
- Masking and protection of adjacent surfaces
- Residue and soap film stripping with pH-neutral products
- Deep cleaning of joints and edges
- Polishing to restore the surface sheen
- Stain treatment for oil, rust and hard water
- Sealing or coating option
- Wash-down and handover
- Free inspection with a residue test on a hidden patch
What each surface needs
| Problem | Cause | Fix |
|---|---|---|
| Grey haze after mopping | Cleaning residue and soap film | Strip, then polish |
| White patches | Hard water and acid contact | pH-neutral clean, fine polish |
| Dark spots and rings | Oil, rust or planters | Poultice, then polish |
| Patchy gloss | Uneven earlier polishing | Grind and polish to one level |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and residue test (free)
- Masking and preparation
- Stripping of residue and old polish
- Polishing to restore the sheen
- Sealing option and handover
Marble Floor Polishing rates in Kolkata
| Work | Guide band | Notes |
|---|---|---|
| Deep cleaning and stripping | Rs 5-15 per sq ft | Residue and film removal |
| Cleaning plus polishing | Rs 15-25 per sq ft | Dull but sound floors |
| Deep clean with grinding | Rs 25-35 per sq ft | Heavy wear and stains |
| Sealing or coating | Quoted after inspection | Wet and high-traffic areas |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Kudghat
Marble Floor Polishing in Kudghat is handled on scheduled routes by our Kolkata team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Kudghat addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Kudghat job handed over for your records
Keeping the finish after the job is done
| Habit | Why it matters |
|---|---|
| Dry dust mopping | Removes grit before it scratches the surface |
| pH-neutral cleaner only | Acid etches marble and bleach dulls the finish |
| Damp mop, never flooding | Standing water leaves marks and weakens joints |
| Mats at entries | Captures grit where it enters |
| Felt pads under furniture | Stops drag marks on polished surfaces |
- A light maintenance polish every 12-18 months keeps gloss without a full job
- Commercial floors are usually re-polished annually, homes every two years
- Sealer or nano coating, where applied, is refreshed on the schedule we hand over
Timing is agreed before the crew arrives: arrival window, the room sequence and the handover time are confirmed in writing, so nobody is waiting around or guessing when the floor will be free.
Quality is checked twice: once mid-job, when the first section is finished and you can see the achievable gloss, and once at handover when the whole surface should read evenly under daylight and under your own lighting.
Nothing is hidden behind a shine. Where a surface has damage that polishing cannot correct, we mark it during inspection and put it in writing, so expectations are set before work starts rather than argued over afterwards.
Why clients book us
- Residue stripped before sealing so nothing is trapped
- Test patch shown before full commitment
- One team for cleaning, polishing and sealing
- 12 years of stone cleaning and polishing
Serving Kolkata and nearby areas
Kolkata jobs are scheduled as a fixed visit batch so the crew and machines travel together and travel cost is not loaded onto your rate. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit. Inspections are booked within 24-48 hours and most jobs take 1-2 days per flat. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Floor Polishing - common questions
Is deep cleaning enough without polishing?
It restores cleanliness but not sheen. If the surface has micro-scratches and worn gloss, cleaning alone will still look grey, and polishing is needed.
Which cleaner should we use afterwards?
A pH-neutral stone cleaner with clean water. Acidic and abrasive products damage polished stone surfaces within a few uses.
How often should stone floors be deep cleaned?
Every six to twelve months for homes and every three to six months in commercial spaces, depending on footfall and cleaning method.
Why does my floor look dull right after mopping?
Because you are looking at cleaning residue and soap film, not the stone. Mopping with the wrong product keeps adding a layer. Stripping it and polishing the surface is what brings the colour back.
Do you cover Kudghat?
Yes. Kudghat is on our regular route with the Kolkata team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Kudghat?
Inspection first, then scheduling. Most Kudghat jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
How often does the floor need a maintenance polish?
Every 12-18 months for homes and every 8-12 months for commercial floors. It is a much smaller job than the original restoration.
Which cleaner should we use?
A pH-neutral stone cleaner with clean water, dried after mopping. Avoid acid, bleach and abrasive powders, which are the main causes of dull and etched floors.
Can maintenance work be done room by room?
Yes. We schedule it in sections so the house stays usable, and it takes a fraction of the time of a full polish.