Marble Floor Polishing in Boral
If your marble has lost its gloss, shows grey walking lanes or looks hazy after mopping, the finish has worn through to the stone. We restore it with a graded diamond sequence and lock the shine in, so the floor holds its look instead of going flat again in a few weeks. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit.
- Gloss reading and scratch inspection
- Correcting damage before the final passes
- Progressive polishing to the finest grit
- Wet working to control heat and dust
At a glance
- Diamond polishing
- Stain removal
- Rate locked in writing
A real before and after photo is added here for the strongest result.
What is included in marble floor polishing
- Wet working to control heat and dust
- Even pressure across lanes and corners
- Optional crystallisation or nano top coat
- Reflection check with you at handover
- Cleaning advice to protect the gloss
- Gloss reading and scratch inspection
- Correcting damage before the final passes
- Progressive polishing to the finest grit
What each surface needs
| Target finish | Grit reached | Best for |
|---|---|---|
| Satin | 800-1500 | Homes, bedrooms |
| High gloss | 1500 | Living rooms, offices |
| Mirror | 3000 | Lobbies, showrooms |
| Mirror plus crystallisation | 3000 plus treatment | Hotels, high traffic |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and gloss target agreed (free)
- Damage correction by grinding or coarse pads
- Progressive polishing to the agreed grit
- Mirror pass, then optional coating
- Reflection check and handover
Marble Floor Polishing rates in Kolkata
| Work | Guide band | Typical case |
|---|---|---|
| Polish to high gloss | Rs 15-25 per sq ft | Sound floors |
| Mirror finish with correction | Rs 25-35 per sq ft | Scratched or patchy floors |
| Mirror with crystallisation | Quoted after inspection | Lobbies, hotels |
| Top-up coating | Quoted after inspection | Longer gloss life |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Boral
Marble Floor Polishing in Boral is handled on scheduled routes by our Kolkata team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Boral addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Boral job handed over for your records
Looking after the finish
| Timeframe | What to do |
|---|---|
| First 24 hours | Stay off coated areas, keep furniture off the floor |
| First week | Dry mop only, no wet mopping, no chemical cleaners |
| Ongoing | pH-neutral cleaner, damp mop, dry after |
| Every 12-18 months | Light maintenance polish to hold the gloss |
- Never use acid, bleach, vinegar or abrasive powder on stone
- Wipe spills promptly, particularly lemon, tea and oil
- Use felt pads on furniture and mats at entry points
- Keep planters and metal legs off wet floors to prevent rust rings
Every job ends with a walkthrough. You see the gloss reading, the treated patches and the joints before the crew packs up, and the same crew owns any correction needed later.
Machines are matched to the job. A 400 mm single-disc machine for open floors, edge machines for skirtings and staircases, and hand blocks for corners and thresholds where a machine cannot safely reach.
Team composition is consistent: a supervisor plus two machine operators on standard jobs, with additional hands for staircases, multiple floors or tight access. The same supervisor stays with the job start to finish.
Why clients book us
- Honest about whether your floor can reach mirror gloss
- Damage corrected first, reflections chased second
- Even finish verified with you before handover
- Silicate, crystallisation and nano options
Serving Kolkata and nearby areas
Kolkata jobs are scheduled as a fixed visit batch so the crew and machines travel together and travel cost is not loaded onto your rate. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit. Inspections are booked within 24-48 hours and most jobs take 1-2 days per flat. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Floor Polishing - common questions
Can every marble floor reach mirror gloss?
Not every one. Hard, dense marbles like Statuario and Makrana take a very high gloss. Softer or heavily damaged stone may top out at a satin finish, and we tell you that before you pay for a mirror attempt.
Does a mirror finish show scratches more?
Yes, gloss reveals rather than hides surface damage. That is why correction comes before the final passes.
How long does mirror gloss last?
Eighteen to twenty-four months in homes and eight to twelve months in lobbies, longer with a silicate or nano coating.
Is a mirror finish slippery?
A mirror surface is smooth when wet. For bathrooms, kitchens and staircases we recommend a satin finish with anti-skid treatment instead.
Do you cover Boral?
Yes. Boral is on our regular route with the Kolkata team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Boral?
Inspection first, then scheduling. Most Boral jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
What should I avoid in the first week?
Wet mopping, chemical floor cleaners, dragging furniture and placing potted plants back on the floor. Dry mopping and clean water only until the finish settles.
Which cleaner do you recommend?
Any pH-neutral stone cleaner, used with clean water and followed by drying. That single habit prevents most of the dullness and staining we are called back to fix.
What voids the finish durability?
Acid and abrasive cleaning. A floor polished this month can look dull in eight weeks if it is mopped with an acidic general-purpose cleaner.