Marble Floor Polishing in Andul Road
If your marble has lost its gloss, shows grey walking lanes or looks hazy after mopping, the finish has worn through to the stone. We restore it with a graded diamond sequence and lock the shine in, so the floor holds its look instead of going flat again in a few weeks. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit.
- Free inspection with a residue test
- Masking of skirting and furniture edges
- pH-neutral deep cleaning, no acid
- Residue and soap film stripping
At a glance
- Diamond polishing
- Stain removal
- Rate locked in writing
A real before and after photo is added here for the strongest result.
What is included in marble floor polishing
- Residue and soap film stripping
- Grout-line and edge cleaning
- Stain treatment where present
- Optional polishing if the surface needs it
- Drying and care guidance
- Free inspection with a residue test
- Masking of skirting and furniture edges
- pH-neutral deep cleaning, no acid
What each surface needs
| Test | What it means | Correct job |
|---|---|---|
| Wipes clean, still grey | Surface is worn | Polishing needed |
| Feels tacky or streaky | Residue build-up | Deep cleaning only |
| Local dark patches | Stains | Stain treatment |
| White marks near taps | Hard water scale | De-scale and neutral clean |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and residue test (free)
- Masking and preparation
- pH-neutral deep clean and stripping
- Joint and edge cleaning
- Handover with a cleaning routine for daily care
Marble Floor Polishing rates in Kolkata
| Work | Guide band | Notes |
|---|---|---|
| Deep cleaning | Rs 5-15 per sq ft | Residue and soil |
| Deep clean with stain treatment | Rs 15-25 per sq ft | Oil, rust, scale |
| Cleaning plus polishing | Rs 25-35 per sq ft | Worn surface |
| Sealing after cleaning | Quoted after inspection | Optional |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Serving Andul Road
Marble Floor Polishing in Andul Road is handled on scheduled routes by our Kolkata team, so travel is planned rather than added as a surprise.
- Site inspection booked within 24-48 hours for Andul Road addresses
- Society gate, lift and parking permissions coordinated before the crew arrives
- Water point, power and work area confirmed at the time of booking
- Slurry and waste removed the same day, never dumped in the society bins
- Before-and-after photographs of your own Andul Road job handed over for your records
The process, step by step
- Site inspection, gloss reading and hidden test patch
- Masking of skirting, fittings, doors and furniture edges
- Residue and old polish stripping where present
- Grinding if lippage or deep damage is found
- Progressive polishing through the grit sequence
- Optional silicate, crystallisation, epoxy or nano finish
- Edge and corner hand work
- Wash-down, walkthrough and care guidance
Each stage is completed on the whole area before the next one starts, so the floor never ends up with a bright patch next to an unfinished section.
After-care guidance is handed over in writing: which cleaner to use, how to mop, and what to avoid during the first week. Most repeat problems trace back to cleaning products rather than the work itself.
Protection is planned, not improvised. Furniture is moved to one side and covered, curtain hems are lifted, and a walking route is kept clear throughout so the household can still move around.
Access is confirmed before the visit: parking, lift use, gate entry, working-hour restrictions and any society paperwork. Sorting this in advance is what stops a scheduled job from becoming a wasted trip.
Why clients book us
- pH-neutral products on all calcite stone
- Honest advice when cleaning alone is not enough
- Daily-care routine explained at handover
- 12 years of stone cleaning
Serving Kolkata and nearby areas
Kolkata jobs are scheduled as a fixed visit batch so the crew and machines travel together and travel cost is not loaded onto your rate. Kolkata buildings are older and often mix marble, Kota and mosaic in the same flat, with high humidity and monsoon damp that dulls floors faster than in Delhi. Salt-laden air near the river also leaves a film that looks like stone wear but is surface deposit. Inspections are booked within 24-48 hours and most jobs take 1-2 days per flat. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Floor Polishing - common questions
How often should marble be deep cleaned?
Every six to twelve months in homes, and every three to six months in commercial spaces. Daily mopping with the wrong product makes build-up worse, not better.
Which cleaner should we use daily?
A pH-neutral stone cleaner with clean water, and dry the surface afterwards. Acid and abrasive cleaners damage polished marble within a few uses.
Can cleaning remove white patches near taps?
Hard-water scale yes, with a descaling clean. Etch marks caused by acid need light grinding and polishing, which is a different job.
Do I need cleaning or polishing?
Test one patch with a clean damp cloth. If it wipes clean but still looks grey, the surface is worn and needs polishing. If the cloth comes away dirty or the floor is streaky, it needs deep cleaning.
Do you cover Andul Road?
Yes. Andul Road is on our regular route with the Kolkata team, and inspections there are usually booked within 24-48 hours. For larger areas we schedule a fixed route day so travel cost is shared.
How soon can work start in Andul Road?
Inspection first, then scheduling. Most Andul Road jobs begin within a week of approval, and single-room works are often earlier if you are flexible on the date.
How long does each step take?
As a guide, preparation is under an hour, grinding runs 25-40 minutes per 100 sq ft, polishing 15-25 minutes, and finishing plus clean-up about an hour. Bigger areas are scheduled over more days.
Can steps be skipped to save money?
Not safely. Skipping grit stages is the most common shortcut and shows up as scratch haze within weeks. If you want to reduce cost, reduce the area covered this cycle, not the process.
Do you work in one room or the whole floor at a time?
Room by room if you are living in, whole floor if the house is empty, which produces a more even finish because lighting and drying are consistent.