Marble Installation and Fitting in Delhi
We lay, level and finish marble so the joints are tight, the surface is flat and the polish takes evenly. Bad fitting is what forces grinding later, and that costs more than doing it right. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble.
- Site measurement and layout plan
- Levelling of the base and checking for hollowness
- Laying with correct joint width
- Edge cutting for skirting, thresholds and columns
At a glance
- 12 years experience
- 600+ projects a year
- Written rates
A real before and after photo is added here for the strongest result.
What is included in marble installation
- Site measurement and layout plan
- Levelling of the base and checking for hollowness
- Laying with correct joint width
- Edge cutting for skirting, thresholds and columns
- Joint filling and levelling
- Grinding and polishing after laying
- Grout line finishing
- Clean-up and handover
What each surface needs
| Stage | What matters | Why |
|---|---|---|
| Base | Level, clean, sound | Prevents hollow slabs |
| Joint width | Kept tight and even | Wide joints need grinding |
| Levelling | No lippage between slabs | Saves the polishing stage |
| Finishing | Polished after laying | One uniform gloss |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Measurement and layout approval
- Base preparation and levelling
- Laying and joint alignment
- Joint filling and grinding
- Polishing, clean-up and handover
Marble Installation rates in Delhi
| Work | Pricing | Notes |
|---|---|---|
| Laying and fitting | Per sq ft | Marble, granite, tile |
| Grinding after laying | Per sq ft | Lippage removal |
| Polishing after laying | Per sq ft | Finish choice |
| Skirting and edge work | Per running ft | Cutting and finishing |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
Why clients book us
- 12 years of laying and finishing stone in Delhi NCR
- Base checked for hollowness before laying
- Tight joints as standard, so grinding is not needed later
- Polishing done by the same team that laid the floor
- Square metre rates confirmed in writing first
Serving Delhi and nearby areas
The Delhi team operates out of Badarpur, close to the Mathura Road corridor and South Delhi. Delhi floors take a beating from dust, metro-era construction grit and hard water. Makrana, Katni and Kota dominate older colonies, while newer builder floors use imported marble. Inspections are booked within 24-48 hours and most flats are finished the same day. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Installation - common questions
What causes hollow slabs after installation?
Almost always a base that was not levelled or cleaned properly, or cement laid too dry. Tapped hollow slabs have to be lifted and re-laid, which is why we check the base first.
Should new marble be polished immediately?
After laying and joint filling it should be levelled and polished so the whole floor ends up with one finish. Waiting leaves the floor open to staining around the joints.
Do you handle cutting around columns and skirting?
Yes. Edge cutting and skirting work is quoted per running foot and finished before the final polish.
Can you match marble from an older lot?
Matching is possible but never exact. Send a photo and we will show you the closest available lots before ordering.