Marble Floor Restoration in Patna
Some damage will not polish out because it is chemical, not wear. We identify each mark, treat it with the right method, then polish the whole floor back to one even finish. Patna homes lean heavily on marble and Kota stone laid years ago, and dust plus monsoon humidity make those floors look permanently grey. Grinding is usually needed before polishing shows any real gloss.
- Free inspection of porosity and stain history
- Deep cleaning before sealing (sealer over dirt seals dirt)
- Drying time allowed, no sealing on damp stone
- Impregnating sealer applied evenly
At a glance
- Etch repair
- Poultice treatment
- Colour-matched fills
A real before and after photo is added here for the strongest result.
What is included in marble floor restoration
- Drying time allowed, no sealing on damp stone
- Impregnating sealer applied evenly
- Second coat on high-absorption stone
- Buffer and residue removal
- Wet-area and kitchen priority treatment
- Maintenance and re-seal schedule explained
- Free inspection of porosity and stain history
- Deep cleaning before sealing (sealer over dirt seals dirt)
What each surface needs
| Stone | Absorption | Seal priority |
|---|---|---|
| Marble | Medium, acid and oil sensitive | Kitchens, entries, washbasins |
| Limestone | High | All wet areas |
| Granite | Low | Kitchen platforms, stairs |
| Travertine | High, pitted | Bathrooms, outdoors |
Every surface is tested on a hidden patch before work starts, so you see the result before committing to the whole floor.
How the job runs
- Inspection and porosity test (free)
- Deep cleaning and residue removal
- Full drying of the stone surface
- Sealer applied in even coats
- Buffing, handover and re-seal schedule
Marble Floor Restoration rates in Patna
| Work | Guide band | Notes |
|---|---|---|
| Clean and seal | Rs 5-15 per sq ft | Dry floors and walls |
| Strip, clean and seal | Rs 15-25 per sq ft | Old coating present |
| High-absorption stone, two coats | Quoted after inspection | Limestone and travertine |
| Re-seal cycle | Per sq ft | Every 12-24 months |
Rates depend on surface type, damage depth, area and access. The figure is written down before work begins.
How to get a quote that does not change
- WhatsApp photos of the dullest area and the worst stain speed up the first estimate
- A free on-site inspection gives the final figure, because gloss readings and damage depth cannot be judged from a photo
- The written quote lists surface by surface: area, rate, scope and exclusions
- Coatings, crack repairs and slab replacement appear as separate optional lines
- The figure is valid for thirty days unless you ask us to hold it longer
If a contractor quotes a single number for a whole house without inspecting it, that number will change once work starts. We would rather quote after looking.
Weight and load matter on upper floors and terraces. Where a slab has been laid over a void or a lightweight screed, we reduce machine weight and speed rather than risk cracking the base.
Team composition is consistent: a supervisor plus two machine operators on standard jobs, with additional hands for staircases, multiple floors or tight access. The same supervisor stays with the job start to finish.
The written rate is the final amount for the agreed scope. If we open the floor and find something the inspection could not show, we stop and re-quote with you before continuing, not after.
Why clients book us
- 12 years of stone care
- Sealer applied only on clean, dry stone
- Impregnating sealers used, not film coatings
- Honest about what sealing does and does not do
Serving Patna and nearby areas
Patna work is booked as a scheduled visit batch with the full machine set. Patna homes lean heavily on marble and Kota stone laid years ago, and dust plus monsoon humidity make those floors look permanently grey. Grinding is usually needed before polishing shows any real gloss. Inspections are booked within 24-48 hours and most jobs take 1-2 days depending on area. Call 86070 01043 or WhatsApp photos of your floor for an indicative rate.
Marble Floor Restoration - common questions
Will sealing make my marble stain-proof?
No, and any contractor saying that is overselling. Sealing buys you time to wipe a spill. Lemon juice or oil left overnight can still mark sealed stone.
How often should stone be re-sealed?
Every twelve to twenty-four months for working areas like kitchens, entries and washbasins. Dry bedroom floors and walls hold sealer much longer.
Can sealer be applied over an old polish?
No. It will not bond, and it traps the old residue underneath. Cleaning or stripping first is part of the job, not an optional extra.
Does sealing change the colour?
Impregnating sealers are colourless. If a sealer darkens the stone, it is a film-forming product rather than an impregnator, which is a different finish choice.
Can I get a quote on WhatsApp?
Yes as an indicative band. Send photos in daylight of the dullest area, any stains and one close-up of the surface. The final figure is confirmed after the free on-site inspection.
How long is the quote valid?
Thirty days from the inspection date. Material and product rates move, so we do not hold figures indefinitely, but we will tell you if anything changes.
Is the inspection really free?
Yes. There is no charge for the site visit or the measurement, and no obligation to proceed afterwards.